Anti-corrosion wood in Guizhou

Anti-corrosion wood in Guizhou

Since the use of a wood structure with a high water content is likely to cause later deformation and cracking, it is generally required that the outdoor wood should be dried in a cool place before construction to adapt to the humid external environment. same. At the construction site, Guizhou anti-corrosion wood should be stored in a ventilated place, avoiding sunlight as much as possible. Considering the service life of the anti-corrosion wood, it is recommended to use the existing anti-corrosion wood size on the construction site. If on-site treatment is required, all cuts and holes should be thoroughly brushed with appropriate preservatives. For aesthetic considerations, it is best to build a platform with long planks to reduce the seams; and there is a gap of 5mm-10mm between the boards. The installation of the fixed keel must be based on the foundation to ensure that the height of the entire platform is the same after installation. The keel must be preserved, and the spacing between two adjacent keels should be proportional to the thickness of the platform plate, preferably less than 1 meter or equal to 1 meter. To prevent corrosion, it is best to connect the platform plate to the keel with galvanized or stainless steel cones. Two nails were used, nailing each board to the keel contact. It is best not to use different metal parts because it will rust quickly. After installing the platform, apply wood oil on the surface of the board to achieve the effect of protecting the board clean and beautiful. Traditional paint is not recommended. The wood oil is transparent and colored, and a protective film can be coated on the wood surface to make it waterproof, anti-foam, anti-stripping, and anti-ultraviolet. Avoid the problems of old wood, dirty and easy to clean. Paint dripping is also a problem with wood preservation. Affected by environmental factors such as resin, wood, ultraviolet rays, water vapor, and temperature changes, it is easy to cause spots or peeling off of the paint film, not to mention the wear and tear generated during the use of anticorrosive wood production equipment, which will cause corrosion prevention. Wood paint and fade. Therefore, we need to spend more energy on wood drying or painting and corrosion treatment. We must strengthen maintenance during use, and use paint and other protective agents for maintenance every rainy season or before winter. Wood can be made of large-section plywood, gypsum board or gypsum board, or impregnated with flame retardants or coated with flame retardant coatings. The reason why Guizhou anticorrosive wood wholesale is called anticorrosive wood is not because it will not rot, but because it is more resistant to corrosion than ordinary wood, so it can be used for a longer time for anticorrosive wood, or the corresponding preservatives should be carried out. deal with. In fact, these phenomena are very common in outdoor open-air landscapes, because the expansion and contraction rate, rotary cutting and diameter cutting of heartwood and sapwood are different, and changes in air temperature and humidity affect moisture absorption and balance moisture content. Exposed wood is exposed outdoors. The above phenomenon can shorten the service life of the anticorrosive wooden pavilion. In this case, we need to choose materials when wood has good stability.

Related Products